This script can be used to control older Magstim 200 models that have been fitted with the parallel port modification, using multiple states and the 1401 digital outputs. The script creates a suitable sampling configuration and allows the user to specify the Magstim output intensities and interval between outputs for each state used.
The connection between the Magstim parallel port interface and the 1401 digital outputs can be achieved with a modified data cable (contact us for details).
This script requires Signal v3.10 or higher
Keywords: Magstim 200
This script demonstrates how to place a waveform output configuration into an output file and how to set the values of the waveform.
It will adjust the currently loaded sampling configuration to put a high-speed waveform output section into it. It is a simple example of defining and controlling the waveform.
The code as it stands simply sets a few locations to 32767 (= 5 volts) to generate a short square pulse, but it is easily modifiable to allow you to create any desired waveform.
This script provides calibration of data read from one or more ADC ports using sampled data corresponding to known calibrated values. It also allows zeroing of the calibration using a known zero signal. The script can be used as is to calibrate Signal data acquisition or the script could be copied into other scripts or modified to provide customised calibration mechanisms. The file calib.doc contains more information about using this script.
These scripts are stored as WinZip files, myscript.zip, except where they are shown as signal\scripts\myscript.sgs. Those files were installed with Signal. See the summaries by clicking on the description line, below. Then you can down-load them by clicking on the filename; please check the size received.